Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) User Manual
Page 173
Brocade Virtual ADX MIB Reference
161
53-1003312-01
OSPF virtual interface status table
snOspfVirtIfStatusAuthType
brcdIp.1.2.4.13.1.1.10
Syntax: Integer32
Read only
Specifies the authentication type for an interface.
Valid values::
•
none(0)
•
simplePassword(1)
•
reserved for specification by IANA(> 1)
Additional authentication types may be assigned locally on a per
interface basis.
Default: none(0)
snOspfVirtIfStatusAuthKey
brcdIp.1.2.4.13.1.1.11
Syntax: OctetString
Read only
Specifies the authentication key.
•
If the authentication type selected is simple password, then this
object requires an alphanumeric password. If the value is
shorter than eight octets, the agent will left-adjust and zero-fill
the key to equal eight octets.
The simple password setting takes effect immediately. All OSPF
packets transmitted on the interface contain this password. Any
OSPF packet received on the interface is checked for this
password. If the password is not present, then the packet is
dropped. The password can be up to eight characters long.
•
If the authentication type is MD5, then a key ID and an MD5 key
are required. The key ID is a number from 1 to 255 and identifies
the MD5 key that is being used. The MD5 key can be up to
sixteen alphanumeric characters long.
When read,
Reference: RFC 1583 “OSPF Version 2”, section 9 The Interface Data
Structure
Default: ’0000000000000000’h – 0.0.0.0.0.0.0.0
snOspfVirtIfStatusMd5AuthKe
yId
brcdIp.1.2.4.13.1.1.12
Syntax: Integer
Read only
Specifies the ID of the MD5 authentication key. This object identifies
the algorithm and secret key used to create the message digest
appended to the OSPF packet. Key identifiers are unique per
interface.
If the object
is set to MD5, the value of this
object must be a number from 1 – 255.
snOspfVirtIfStatusMd5AuthKe
y
brcdIp.1.2.4.13.1.1.13
Syntax: OctetString
Read only
Specifies the MD5 authentication key. The value of this object is
encrypted and included in each OSPF packet transmitted.
If the value of this object is shorter than 16 octets, the agent will
left-adjust and zero-fill the key to equal 16 octets.
When read, snOspfIfMd5AuthKey always returns a blank.
snOspfVirtIfStatusMd5Activati
onWaitTime
brcdIp.1.2.4.13.1.1.14
Syntax: Integer
Read only
Determines when a newly configured MD5 authentication key is valid.
This parameter provides a graceful transition from one MD5 key to
another without disturbing the network. All new packets transmitted
after the key activation wait time interval use the newly configured
MD5 key. OSPF packets that contain the old MD5 key are accepted
for up to five minutes after the new MD5 key is in operation. The
range for the key activation wait time is from 0 – 14400 seconds.
snOspfVirtIfStatusAreaIdForm
at
brcdIp.1.2.4.13.1.1.15
Syntax: Integer
Read only
Specifies the format of how Area ID will be entered in the
object:
•
integer(0) – Integer
•
ipAddress(1) – IP address
Name, OID, and Syntax
Access
Description