Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 201)

Brocade Virtual ADX MIB Reference 189
53-1003312-01
Real server objects
• The Real Server Table (snL4RealServerTable) has been deprecated and replaced by
the Real Server Configuration Table (snL4RealServerCfg).
• Real Server Port Table (snL4RealServerPortTable) has been replaced by the Real
Server Port Configuration Table (snL4RealServerPortCfg).
• Real Server Status Table (snL4RealServerStatusTable) has been replaced by the Real
Server Statistics Table (snL4RealServerStatistic).
• The Real Server Port Status Table (snL4RealServerPortStatusTable) has been
replaced by the Real Server Statistics Table (snL4RealServerPortStatisticTable).
This section presents the following tables:
• “Real server configuration table” on page 189
• “Real server port configuration table” on page 190
• “Real server statistics table” on page 191
• “Real server port statistic table” on page 194
Additional tables for real servers are included in the section “Monitor groups” on page 208 . Those
tables provide historical information on data samples for real servers and real server ports.
Real server configuration table
The Real Server Configuration table shows the configuration of real servers. A real server is an
application server which is load-balanced by the SLB switch.
Name, OID, and Syntax Access Description
snL4RealServerCfgTable
brcdIp.1.1.4.19.1 None Real Server Configuration Table.
snL4RealServerCfgEntry
brcdIp.1.1.4.19.1.1 None An entry in the Real Server Configuration Table.
snL4RealServerCfgIP
brcdIp.1.1.4.19.1.1.1
Syntax: IpAddress Read only Shows the IP address of the real server.
snL4RealServerCfgName
brcdIp.1.1.4.19.1.1.2
Syntax: L4ServerName Read-write Shows the name of the real server. This name must be
unique among the real server names.
Valid values: 1– 32 octets
snL4RealServerCfgAdminStatus
brcdIp.1.1.4.19.1.1.3
Syntax: L4Status Read-write Enables or disables the real server:
•
disabled(0)
•
enabled(1)
snL4RealServerCfgMaxConnections
brcdIp.1.1.4.19.1.1.4
Syntax: Integer Read-write Specifies the maximum number of connections the
ServerIron can maintain in its session table for a real server.
When a real server reaches this threshold, an SNMP trap is
sent. When all the real servers in a server pool reach this
threshold, additional TCP or UDP packets are dropped, and
an ICMP destination unreachable message is sent.
Valid values: 1 to 2000000