Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 100)

88 Brocade Virtual ADX MIB Reference
53-1003312-01
ACLs
ACL port table (snAgAclIfBindTable)
The snAgAclIfBindTable is deprecated and has been replaced with snAgAclTable (refer to “IPv4 ACL
table” ).
snAgBindPortListInVirtualIn
terface
brcdIp.1.2.2.15.3.1.5
Syntax: OctetString Read-write Contains a list of ports for binding virtual interface
snAgAclPortRowStatus
brcdIp.1.2.2.15.3.1.6
Syntax: SnRowStatus Read-write Controls the management of the table rows. The values that can be
written are:
•
delete(3) – Delete the row
•
create(4) – Create a new row
•
modify(5) – Modify an existing row
If the row exists, then a SET with a value of create(4) returns a "bad
value" error. Deleted rows are removed from the table immediately.
The following values can be returned on reads:
•
noSuch(0) – No such row
•
invalid(1) – Row is inoperative
•
valid(2) – Row exists and is valid
Name, OID, and Syntax Access Description
snAgAclIfBindTable
brcdIp.1.2.2.15.4 None The ACL Bind to Port Table
snAgAclIfBindEntry
brcdIp.1.2.2.15.4.1 None An entry in the ACL Bind to Port table
snAgAclIfBindIndex
brcdIp.1.2.2.15.4.1.1
Syntax: InterfaceIndex Read only The number of the virtual or physical interface to which this ACL is
bound.
snAgAclIfBindDirection
brcdIp.1.2.2.15.4.1.2
Syntax: Direction Read only Shows the traffic direction to which the ACL will be applied:
•
inbound(0)
•
outbound(1)
snAgAclIfBindNum
brcdIp.1.2.2.15.4.1.3
Syntax: INTEGER Read-write Shows the defined ACL number that will be bound to the port.
snAgAclIfBindNameString
brcdIp.1.2.2.15.4.1.4
Syntax: DisplayString Read-write Shows the defined ACL name that will be bound to the port.
Name, OID, and Syntax Access Description