Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) User Manual
Page 117
Brocade Virtual ADX MIB Reference
105
53-1003312-01
Port VLAN configuration table
snVLanByPortCfgStpGroup
MaxAge
brcdIp.1.1.3.2.7.1.5
Syntax: Integer32
Read-write
Shows the value of dot1dStpBridgeMaxAge, which is the last six octets
or the STP or RSTP bridge ID. All bridges use this object for MaxAge
when this bridge is acting as the root.
NOTE: 802.1D-1990 specifies that the range for this parameter is
related to the value of dot1dStpBridgeHelloTime in the object
“snVLanByPortStpGroupHelloTime”.
The granularity of this timer is specified by 802.1D-1990 to be
one second. An agent may return a badValue error if a set is
attempted to a value which is not a whole number of seconds.
(Refer to RFC 1493 Bridge MIB.)
Valid values: 6 – 40.
snVLanByPortCfgStpGroup
Hello Time
brcdIp.1.1.3.2.7.1.6
Syntax: Integer
Read-write
Shows the value of the dot1dStpBridgeHelloTime, which is the value
used by all bridges when this bridge is acting as the root.
The granularity of this timer is specified by 802.1D-1990 to be one
second. An agent may return a badValue error if a set is attempted to a
value which is not a whole number of seconds.
(Refer to RFC1493 Bridge MIB.)
Valid values: 1 – 10
snVLanByPortCfgStpGroupF
orwardDelay
brcdIp.1.1.3.2.7.1.7
Syntax: Integer32
Read-write
Shows the value of dot1dStpBridgeForwardDelay, which is the value
used by all bridges for ForwardDelay when this bridge is acting as the
root.
NOTE: 802.1D-1990 specifies that the range for this parameter is
related to the value of dot1dStpBridgeMaxAge, which is in the
object
.
The granularity of this timer is specified by 802.1D-1990 to be
one second. An agent may return a badValue error if a set is
attempted to a value which is not a whole number of seconds.
(Refer to RFC1493 Bridge MIB).
snVLanByPortCfgBaseNum
Ports
brcdIp.1.1.3.2.7.1.8
Syntax: Integer32
Read only
The number of ports controlled by this bridging entity.
snVLanByPortCfgBaseType
brcdIp.1.1.3.2.7.1.9
Syntax: Integer
Read only
Indicates what type of bridging this bridge can perform. If a bridge is
actually performing a certain type of bridging this will be indicated by
entries in the port table for the given type.
•
unknown(1),
•
transparentOnly(2),
•
sourcerouteOnly(3),
•
srt(4))
snVLanByPortCfgStpProtoc
olSpecification
brcdIp.1.1.3.2.7.1.10
Syntax: Integer
Read only
Shows what version of STP is being run:
•
unknown(1)
•
decLb100(2) – Indicates the DEC LANbridge 100 Spanning Tree
protocol
•
ieee8021d(3) – Return "ieee8021d(3)". If future versions of the
IEEE Spanning Tree Protocol are released that are incompatible
with the current version, a new value will be defined.
Name, OID, and Syntax
Access
Description