Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 66)

54 Brocade Virtual ADX MIB Reference
53-1003312-01
Switch port information
snSwIfInfoConnectorType
brcdIp.1.1.3.3.5.1.9
Syntax: Integer Read only Shows the type of connector that the port offers:
•
other(1) – Other or unknown connector
•
copper(2) – Copper connector
•
fiber(3) – Fiber connector This describes the physical
connector type
snSwIfInfoAdminStatus
brcdIp.1.1.3.3.5.1.10
Syntax: Integer Read-write Shows the desired state of all ports.
•
up(1) – Ready to pass packets
•
down(2)
•
testing(3) – No operational packets can be passed (same as
ifAdminStatus in MIB-II)
snSwIfInfoLinkStatus
brcdIp.1.1.3.3.5.1.11
Syntax: Integer Read only Shows the current operational state of the interface.
•
up(1) – Ready to pass packets
•
down(2)
•
testing(3) – No operational packets can be passed (same as
ifAdminStatus in MIB-II)
snSwIfInfoPortQos
brcdIp.1.1.3.3.5.1.12
Syntax: Integer Read-write Indicates the quality of service level selected for the port.
For stackable devices, the QoS can be one of the following:
•
low(0) – low priority
•
high(1) – high priority.
•
level0(0) – best-effort queue
•
level1(1) – normal priority queue
•
level2(2) – high priority queue
•
level3(3) – premium (highest-priority) queue
For chassis devices, the values can be:
•
level0(0)
•
level1(1)
•
level2(2)
•
level3(3)
•
level4(4)
•
level5(5)
•
level6(6)
•
level7(7)
snSwIfInfoPhysAddress
brcdIp.1.1.3.3.5.1.13
Syntax: Physical address Read only Shows the port’s physical address.
snSwIfLockAddressCount
brcdIp.1.1.3.3.5.1.14
Syntax: Integer Read-write Indicates the number of source MAC addresses that are allowed
on the interface.
Valid values: 0 – 2048. If you enter 0 allow an unlimited number
of addresses.
Default: 8
snSwIfStpPortEnable
brcdIp.1.1.3.3.5.1.15
Syntax: Integer Read-write Indicates if STP is enabled for the port:
•
disabled(0)
•
enabled(1)
Refer to the document IEEE 802.1D-1990: Section 4.5.5.2,
dot1dStpPortEnable.
snSwIfDhcpGateListId
brcdIp.1.1.3.3.5.1.16
Syntax: Integer Read-write Specifies the ID for a DHCP gateway list entry relative to this
switch port.
Valid values: 0 – 32. A value of 0 means that the ID is
unassigned.
Name, OID, and Syntax Access Description