Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 67)

Brocade Virtual ADX MIB Reference 55
53-1003312-01
Switch port information
snSwIfName
brcdIp.1.1.3.3.5.1.17
Syntax: Display string Read-write Indicates the port name or description. This description may have
been entered using the CLI.
Valid values: Up to 32 characters for most devices.
snSwIfDescr
dry.1.1.3.3.5.1.18
Syntax: Display string Read-write The name of the interface.
snSwIfInfoAutoNegotiate
brcdIp.1.1.3.3.5.1.19
Syntax: Integer Read-write Applies only to Gigabit Ethernet ports.
Indicates if auto-negotiation mode is enabled on the port.
•
disable(0) – The port will be placed in non-negotiation mode.
•
enable(1) – The port will start auto-negotiation indefinitely
until it succeeds.
•
negFullAuto(2) – The port will start with auto-negotiation. If
the negotiation fails, then it will automatically switch to
non-negotiation mode. This option is not supported in
stackable products with Gigabit Ethernet ports, except for
TurboIron/8.
•
global(3) – The port negotiation mode follows the value of
snSwGlobalAutoNegotiate.
•
other(4) – Non-Gigabit Ethernet.
Default: global(3)
snSwIfInfoFlowControl
brcdIp.1.1.3.3.5.1.20
Syntax: Integer Read-write Indicates if port flow control is enabled:
•
disable(0)
•
enable(1)
Default: enabled(1)
snSwIfInfoGigType
brcdIp.1.1.3.3.5.1.21
Syntax: Integer Read only Applies only to Gigabit Ethernet ports.
Shows the media type for the port:
•
m1000BaseSX(0) – 1-Gbps fiber, with a short wavelength
transceiver
•
m1000BaseLX(1) – 1-Gbps fiber, with a long wavelength
transceiver (3km)
•
m1000BaseLH(2) – 1-Gbps fiber, with a special wavelength
transceiver (50km)
•
m1000BaseLHB(4) – 1-Gbps fiber, with a special
wavelength transceiver (150km).
•
m1000BaseTX(5) – 1-Gbps copper (100meter).
•
m10000BaseSR(6) – 10-Gbps fiber, with a short range
wavelength transceiver (100m).
•
m10000BaseLR(7) – 10-Gbps fiber, with a long range
wavelength transceiver (10km).
•
m10000BaseER(8) – 10-Gbps fiber, with a extended range
wavelength transceiver (40km).
•
notApplicable(255) – a non-gigabit port.
snSwIfFastSpanPortEnable
brcdIp.1.1.3.3.5.1.22
Syntax: Integer Read-write Indicates if fast span is enabled on the port.
•
disable(0)
•
enable(1)
snSwIfFastSpanUplinkEnable
brcdIp.1.1.3.3.5.1.23
Syntax: Integer Read-write Indicates if fast span uplink is enabled on the port.
•
disable(0)
•
enable(1)
Name, OID, and Syntax Access Description