Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 158)

146 Brocade Virtual ADX MIB Reference
53-1003312-01
OSPF virtual interface table
snOspfVirtIfAreaID
brcdIp.1.2.4.5.1.1.1
Syntax: AreaID Read only Specifies the ID of the transit Area that the Virtual link traverses. A
value of 0.0.0.0 is not valid.
snOspfVirtIfNeighbor
brcdIp.1.2.4.5.1.1.2
Syntax: RouterID Read only Shows the IP address of the ID of the router that is serving as the
virtual neighbor.
snOspfVirtIfTransitDelay
brcdIp.1.2.4.5.1.1.3
Syntax: UpToMaxAge Read-write Shows the time it takes to transmit link-state update packets on this
interface.
Valid values: 0 – 3600 seconds
Default: 1 second
snOspfVirtIfRetransInterval
brcdIp.1.2.4.5.1.1.4
Syntax: UpToMaxAge Read-write Specifies the interval between the retransmission of link-state
advertisements to router adjacencies for this interface.
Valid values: 0 – 3600 seconds
Default: 5 seconds
This value is also used when retransmitting database description
and link-state request packets. This value should be greater than
the expected roundtrip time.
snOspfVirtIfHelloInterval
brcdIp.1.2.4.5.1.1.5
Syntax: HelloRange Read-write Specifies the number of seconds that router waits before it sends
the next Hello packet on this interface. This value must be the same
for all routers attached to a common network.
Valid values: from 1 – 65535 seconds
Default: 10 seconds
This value must be the same for the virtual neighbor.
snOspfVirtIfRtrDeadInterval
brcdIp.1.2.4.5.1.1.6
Syntax: PositiveInteger Read-write Specifies the number of seconds that neighbor routers wait for a
router’s Hello packets before they declare that the router is down.
This should be a multiple of the Hello interval. This value must be
the same for the virtual neighbor.
Default: 60 seconds
snOspfVirtIfAuthType
brcdIp.1.2.4.5.1.1.7
Syntax: Integer Read-write Specifies the authentication type for an interface.
Valid values:
•
none(0)
•
simplePassword(1)
•
md5(2)
•
reserved for specification by IANA(> 2)
Additional authentication types may be assigned locally on a per
interface basis.
Default: none(0)
Name, OID, and Syntax Access Description