Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 144)

132 Brocade Virtual ADX MIB Reference
53-1003312-01
IP prefix list table
snIpPrefixListDesc
brcdIp.1.2.2.14.1.3
Syntax: OctetString Read-write Specifies the description of the prefix. This description is in an octet
string; each character in the description is represented by one octet.
There can be up to 80 octets in the description.
snIpPrefixListAction
brcdIp.1.2.2.14.1.4
Syntax: Integer Read-write Indicates what to do with the route if it matches this entry:
•
deny(0)
•
permit(1)
snIpPrefixListAddr
brcdIp.1.2.2.14.1.5
Syntax: IpAddress Read-write Shows the IP address of the prefix.
snIpPrefixListMask
brcdIp.1.2.2.14.1.6
Syntax: IpAddress Read-write Shows the number of bits in the prefix network mask.
snIpPrefixListGeValue
brcdIp.1.2.2.14.1.7
Syntax: Integer Read-write Specifies that the prefix is greater than the value of the
“snIpPrefixListMask” object.
Valid values: 0 – 32
snIpPrefixListLeValue
brcdIp.1.2.2.14.1.8
Syntax: Integer Read-write Specifies that the prefix is less than the value of the
“snIpPrefixListMask” object.
Valid values: 0 – 32
NOTE: You can specify a range of length for prefixes that are more specific than the values for the
“snIpPrefixListAddr” and “snIpPrefixListMask” objects. The or you specify must
meet the following condition:
length < ge-value <= le-value <= 32
If a value for “snIpPrefixListGeValue” is specified, then the mask-length range is from the value of
“snIpPrefixListGeValue” to 32.
If a value for “snIpPrefixListLeValue” is specified, then mask-length range is from length to the value of
“snIpPrefixListLeValue” .
If no value is specified for either the less than or greater than objects, then routes must exactly match the prefixes
on the list.
snIpPrefixListRowStatus
brcdIp.1.2.2.14.1.9
Syntax: Integer Read-write Controls the management of the table rows. The values that can be
written are:
•
delete(3) – Delete the row
•
create(4) – Create a new row
•
modify(5) – Modify an existing row
If the row exists, then a SET with a value of create(4) returns a "bad
value" error. Deleted rows are removed from the table immediately.
The following values can be returned on reads:
•
noSuch(0) – No such row
•
invalid(1) – Row is inoperative
•
valid(2) – Row exists and is valid
snIpPrefixListLength
brcdIp.1.2.2.14.1.10
Syntax: Integer32 Read-write The length of the IP prefix’s mask.
Name, OID, and Syntax Access Description