Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 111)

Brocade Virtual ADX MIB Reference 99
53-1003312-01
Chapter
9
VLANs
In this chapter
• VLAN by port information table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 99
• VLAN by port membership table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 103
• Port VLAN configuration table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 104
• VLAN by protocol configuration table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 107
• VLAN by IP subnet configuration table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 109
• v VLAN by port membership table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 111
• Port VLAN configuration table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 111
VLAN by port information table
The following table applies to a Layer 2 devices if the object “snSwGroupOperMode” on page 23 is
configured with a value of vlanByPort(2), allowing switch ports to be configured with a VLAN ID.
Each VLAN switch port could have a number of VLAN IDs.
Name, OID, and Syntax Access Description
snVLanByPortTable
brcdIp.1.1.3.2.1 None The VLAN by Port Information Table for Layer 2 switches.
snVLanByPortEntry
brcdIp.1.1.3.2.1.1 None An entry in the VLAN By Port Information table.
snVLanByPortVLanIndex
brcdIp.1.1.3.2.1.1.1
Syntax: Integer Read only Shows the index to this table.
The VLAN ID number must not be greater than the value of the
object
“snVLanGroupVlanMaxEntry” on page 25 . Each VLAN
Identifier can be a member of multiple ports.
snVLanByPortVLanId
brcdIp.1.1.3.2.1.1.2 Read-write The VLAN ID index to the this table. Each VLAN Identifier can be a
member of multiple ports.
Valid values: 1 – 4095.
snVLanByPortPortMask
brcdIp.1.1.3.2.1.1.3
Syntax: PortMask Read-write Applies only to ServerIron Stackable devices.
Shows the standalone switch VLAN port membership. This object
was obsoleted for Chassis devices.