Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 259)

Brocade Virtual ADX MIB Reference 247
53-1003312-01
Chapter
15
Traps and Objects to Enable Traps
In this chapter
• Objects to enable or disable standard traps . . . . . . . . . . . . . . . . . . . . . . . . 247
• Objects for traps . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 247
• Standard traps. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 253
• Virtual ADX traps . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 254
Objects to enable or disable standard traps
NOTE
By default, all traps are enabled.
The following objects from RFC 1213 are the standard objects supported in the Virtual ADX MIB.
They are used to set SNMP traps.
Objects for traps
This section present the objects available to enable or disable traps.
Trap information
The following objects provide general information on traps.
Name, OID, and
Syntax Access Description
snmpInTraps
1.3.6.1.2.1.11.19 Read
only Shows the total number of SNMP trap PDUs that have been accepted and
processed by the SNMP protocol.
snmpOutTraps
1.3.6.1.2.1.11.29 Read
only Shows the total number of SNMP trap PDUs that have been generated by the
SNMP protocol.
snmpEnableAuthen
Traps
1.3.6.1.2.1.11.30 Read-
write Indicates if the SNMP agent process is permitted to generate authentication failure
traps. The value of this object overrides any configuration information. This objects
provides a way to disable all authentication failure traps.
NOTE: It is strongly recommended that this object be stored in the non-volatile
memory so that it remains constant between re-initializations of the
network management system.