Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 47)

Brocade Virtual ADX MIB Reference 35
53-1003312-01
General security objects
Configuration notes
When using the snAgGblPassword object in a Set operation, keep the following in mind:
The device will always insist on a password to be part of the object snAgGblPassword. You can
override this requirement by entering a no snmp-server pw-check command on the device’s CLI.
By default, the object uses the value of the enable super-user password configured on the device
as the default password. To allow a device to use other authentication schemes, use one of the
following commands:
• aaa authen snmp default enable | local | none
Using enable tells the device to use the configured enable super-user password. If the enable
super-user password is missing, then the device checks for the if implicit TACACS+ enable
password. The device will store a previous (unrelated to SNMP) implicit enable operation
result, and remember the enable password that was approved by TACACS+. You can enter the
following command to use this method:
SnmpSet(snAgGblPassword.0="", snAgEraseNVRAM.0=3)
Using local instructs the device to use a configured local username and password value. You
can enter the following SNMP command to use this method:
SnmpSet(snAgGblPassword.0=" ", snAgEraseNVRAM.0=3)
Using none tells the device to ignore the value of snAgGblPassword and authentication check
will always pass. You can enter the following SNMP command to use this method:
SnmpSet(snAgGblPassword.0="", snAgEraseNVRAM.0=3)
snAgGblSecurityLevelBin
ding
brcdIp.1.1.2.1.39
Syntax: Integer32 Read only After a network management system logs in to a device with a user ID
and password, the privilege level assigned to that system is saved in
this object. Privilege level can be one of the following:
•
0 – Administration
•
4 – Port configuration
•
5 – Read only
•
255 – Invalid binding
snAgGblEnableSLB
brcdIp.1.1.2.1.40
Syntax: Integer Read only Enables or disables Server Load Balancing:
•
disable(0)
•
enable(1)
snAgGblEnableTelnetSer
ver
brcdIp.1.1.2.1.45
Syntax: Integer Read-write Enables or disables the Telnet server in a device:
•
Disable(0)
•
Enable(1)
Default: enable(1)
snAgGblTelnetPassword
brcdIp.1.1.2.1.46
Syntax: DisplayString Read-write Contains the Telnet access password, which is only used with SNMP
Set. An SNMP-Get produces a zero string. This object can have 48
characters.
This object requires a password to be set for the snAgGblPassword
object.
snAgGblTelnetLoginTime
out
brcdIp.1.1.2.1.60
Syntax: Integer Read-write Indicates how many minutes you have to log in before Telnet is
disconnected.
Valid values: 1 – 10 minutes.
Default: 1 minute
Name, OID, and Syntax Access Description