Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 135)

Brocade Virtual ADX MIB Reference 123
53-1003312-01
IP interface port address table
IP interface port address table
The IP Interface Port Address Table shows the port’s IP address and its port type.
snRtIpFilterRowStatus
brcdIp.1.2.2.3.1.10
Syntax: Integer Read-write Controls the management of the table rows. The values that can be
written are:
•
delete(3) – Delete the row
•
create(4) – Create a new row
•
modify(5) – Modify an existing row
If the row exists, then a SET with a value of create(4) returns a "bad
value" error. Deleted rows are removed from the table immediately.
The following values can be returned on reads:
•
noSuch(0) – No such row
•
invalid(1) – Row is inoperative
•
valid(2) – Row exists and is valid
snRtIpFilterEstablished
brcdIp.1.2.2.3.1.11
Syntax: Integer Read-write Applies only to TCP packets.
Indicates if the filtering of established TCP packets is enabled for
packets that have the ACK or RESET flag on:
•
disabled(0)
•
enabled(1)
snRtIpFilterQosPriority
brcdIp.1.2.2.3.1.12
Syntax: Integer Read-write The router Layer 4 QoS Priority values are:
•
low(0) – lower priority
•
high(1) – higher priority
The Priority values are:
•
level0(0) – lower priority
•
level1(1)
•
level2(2)
•
level3(3),
•
level4(4)
•
level5(5)
•
level6(6)
•
level7(7) – higher priority
Name, OID, and Syntax Access Description
Name, OID, and Syntax Access Description
snRtIpPortAddrTable
brcdIp.1.2.2.6 None IP port address table.
snRtIpPortAddrEntry
brcdIp.1.2.2.6.1 None An entry in the IP Port Address table.
snRtIpPortAddrPortIndex
brcdIp.1.2.2.6.1.1
Syntax: PortIndex Read only The index of the port address entry.
snRtIpPortAddress
brcdIp.1.2.2.6.1.2
Syntax: IpAddress Read only Specifies the port IP address.
snRtIpPortSubnetMask
brcdIp.1.2.2.6.1.3
Syntax: IpAddress Read-write Specifies the port IP address subnet mask.