Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 132)

120 Brocade Virtual ADX MIB Reference
53-1003312-01
IP static route table
IP static route table
The IP Static Route Table contains a list of static routes. These routes can be one of the following
types:
• Standard – the static route consists of the destination network address and network mask,
plus the IP address of the next-hop gateway.
• Interface-based – the static route consists of the destination network address and network
mask, plus the Layer 3 Switch interface through which you want the Layer 3 Switch to send
traffic for the route. Typically, this type of static route is for directly attached to destination
networks.
• Null – the static route consists of the destination network address and network mask, plus the
“null0” parameter. Typically, the null route is configured as a backup route for discarding traffic
if the primary route is unavailable.
IP Static Route Table also serves as the default route table.
Name, OID, and Syntax Access Description
snRtIpStaticRouteTable
brcdIp.1.2.2.2 None IP static route table
snRtIpStaticRouteEntry
brcdIp.1.2.2.2.1 None An entry in the IP static route table.
snRtIpStaticRouteIndex
brcdIp.1.2.2.2.1.1
Syntax: Integer32 Read only The table index for a static route entry.
snRtIpStaticRouteDest
brcdIp.1.2.2.2.1.2
Syntax: IpAddress Read-write Shows the destination IP address of the default route. The
address 0.0.0.0 is the IP address of the default router.
snRtIpStaticRouteMask
brcdIp.1.2.2.2.1.3
Syntax: IpAddress Read-write Shows the subnet mask of the default route’s destination IP
address. The subnet mask 0.0.0.0 is the subnet mask of the
default router.
snRtIpStaticRouteNextHop
brcdIp.1.2.2.2.1.4
Syntax: IpAddress Read-write Shows the IP address of the next-hop router (gateway) for the
route.
snRtIpStaticRouteMetric
brcdIp.1.2.2.2.1.5
Syntax: Integer32 Read-write Shows the metrics to next hop router.
Default: 1