Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 82)

70 Brocade Virtual ADX MIB Reference
53-1003312-01
Packet port information table
POS alarms and error conditions
The following MIB objects belong to the snPOSInfoTable. They allow you to collect errors for POS
SONET links. SONET equipment detects alarms and error conditions from the three layers of the
SONET protocol: section, line, and path. Other devices on the network are notified of these events.
Use the MIB objects below to determine if alarms or error conditions have been reported for POS.
The information is also available when you enter the show controllers pos CLI command.
snPOSStatsInUtilization
brcdIp.1.2.14.1.1.1.31
Syntax: Integer Read only The network utilization by incoming traffic in hundredths of a
percent over a five-minute interval.
NOTE: This object is not supported.
snPOSStatsOutUtilization
brcdIp.1.2.14.1.1.1.32
Syntax: Integer Read only The network utilization by outgoing traffic in hundredths of a
percent over a five-minute interval.
NOTE: This object is not supported.
snPOSTagType
brcdIp.1.2.14.1.1.1.33
Syntax: Integer Read only Shows whether or not the port has a VLAN tag:
•
tagged(1) – The port has a VLAN tag. This port can have
multiple VLANs.
•
untagged(2) – The port is not tagged.
Name, OID, and Syntax Access Description
snPOSStatsB1
brcdIp.1.2.14.1.1.1.34
Syntax: Counter Read only Shows the number of received frames that have parity errors at the
section layer of the SONET link.
snPOSStatsB2
brcdIp.1.2.14.1.1.1.35
Syntax: Counter Read only Shows the number of received frames that have parity errors at the
line layer of the SONET link.
snPOSStatsB3
brcdIp.1.2.14.1.1.1.36
Syntax: Counter Read only Shows the number of received frames that have parity errors at the
path layer of the SONET link.
snPOSStatsAIS
brcdIp.1.2.14.1.1.1.37
Syntax: Counter Read only Shows the number of Alarm Indicator Signals (AIS) that were
received by the interface.
snPOSStatsRDI
brcdIp.1.2.14.1.1.1.38
Syntax: Counter Read only Shows the number of Remote Defect Indicator (RDI) signals that
were received by the interface.
snPOSStatsLOP
brcdIp.1.2.14.1.1.1.39
Syntax: Counter Read only Indicates a loss of pointer (LOP) that results from an invalid path
pointer or if an excessive number of new data flag have been
enabled.
snPOSStatsLOF
brcdIp.1.2.14.1.1.1.40
Syntax: Counter Read only Shows how many times the interface experienced out of frame
alignment problems, which is also called a loss of frame (LOF)
condition.
snPOSStatsLOS
brcdIp.1.2.14.1.1.1.41
Syntax: Counter Read only Indicates the number of times the interface experienced a loss of
signal (LOS). With LOS, incoming signals are all zeros during a 100
microsecond period.
Name, OID, and Syntax Access Description