Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) User Manual
Page 46
34
Brocade Virtual ADX MIB Reference
53-1003312-01
General security objects
snAgGblReadOnlyComm
unity
brcdIp.1.1.2.1.25
Syntax: DisplayString
Read-write
Allows you to configure SNMP read-only community strings for the
device. This object can be used in an SNMP-Set, but not SNMP-Get. Get
will return a blank.
Valid values: Up to 32 characters.
NOTE: To use this object, make sure that "password-change any" has
been configured in the device, to allow passwords to be
updated from SNMP or any method
snAgGblReadWriteComm
unity
brcdIp.1.1.2.1.26
Syntax: DisplayString
Read-write
Allows you to configure SNMP read-write community strings for the
device. This object can be used in an SNMP-Set, but not SNMP-Get. Get
will return a blank.
Valid values: Up to 32 characters.
NOTE: To use this object, make sure that "password-change any" has
been configured in the device, to allow passwords to be
updated from SNMP or any method.
snAgGblCurrentSecurityL
evel
brcdIp.1.1.2.1.27
Syntax: Integer
Read only
Represents the current login security level (0 to 5). Each level of
security requires a password to permit users for different system
configurations. Levels are defined in the
object.
snAgSystemLog
brcdIp.1.1.2.1.20
Syntax: OctetString
Read-write
Indicates whether any network management system has login
privileges. The agent allows only one network management to be
logged in.
The value of this object consists of an octet string, with the first byte
representing the value described below. The following four bytes
contain a secret code.
The value of the first byte can be one of the following:
•
login(1) – Login for a network management system.
•
heartbeat(2) – a value for the login NMS periodically to check in;
Otherwise, the Agent will automatically set this object to logout(3)
after a timeout period.
•
logout(3) – a value for a NMS to logout.
•
changePassword(4) – a value for the login NMS to change
password, only if snAgGblPasswordChangeMode was configured
to “anyMgmtEntity”.
•
changeReadOnlyCommunity(5) – a value for the login NMS to
change the read-only community string, only if
snAgGblPasswordChangeMode was configured to
“anyMgmtEntity”.
•
changeReadWriteCommunity(6) – a value for the login NMS to
change the read-write community string, only if
snAgGblPasswordChangeMode was configured to
“anyMgmtEntity”.
This object requires a password to be set for the snAgGblPassword
object.
snAgGblTelnetTimeout
brcdIp.1.1.2.1.37
Syntax: Integer
Read-write
Shows how many minutes a Telnet session can remain idle before it
times out. The value of this object can be up to 240 minutes. A value of
0 means that the Telnet session never times out.
snAgGblEnableWebMgmt
brcdIp.1.1.2.1.38
Syntax: Integer
Read-write
Enables or disables access to the device from the Web management
interface:
•
disable(0)
•
enable(1)
Name, OID, and Syntax
Access
Description