Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 37)

Brocade Virtual ADX MIB Reference 25
53-1003312-01
Software configuration
snSwGlobalStpMode
brcdIp.1.1.3.1.14
Syntax: Integer Read-write Indicates whether or not Spanning Tree System Global Mode has been
enabled for the switch group.
•
disabled(0)
•
enabled(1)
snSwIpMcastQuerierMode
brcdIp.1.1.3.1.15
Syntax: Integer Read-write The IP Multicast pruning mode is configured either Non-Querier or
Querier mode
•
querier(1) – Send out host queries. (active)
•
nonQuerier(2) – Do not send out host queries.(passive)
Default: querier(1)
snSwViolatorPortNumber
brcdIp.1.1.3.1.17
Syntax: Integer32 Read only Indicates the port number of the switch or router that receives the
violator packet. This number is included in the locked address
violation trap. The value of this object contains the following:
•
Bit 0 to bit 7 – Port number
•
Bit 8 to bit 11 – Slot number (for chassis devices only)
snSwViolatorMacAddress
brcdIp.1.1.3.1.18
Syntax: MAC address Read only Indicates the source MAC address of the violator packet received by
the switch or router. This number is included in the locked address
violation trap.
snVLanGroupVlanMaxEntry
brcdIp.1.1.3.1.19
Syntax: Integer32 Read-write Shows the maximum number of VLAN entries that can be configured.
snSwEosBufferSize
brcdIp.1.1.3.1.20
Syntax: Integer32 Read only Specifies buffer size for all the different EOS buffers.
snVLanByPortEntrySize
brcdIp.1.1.3.1.21
Syntax: Integer32 Read only Specifies the size of each VLAN table entry.
snSwPortEntrySize
brcdIp.1.1.3.1.22
Syntax: Integer32 Read only Specifies the size of each port table entry.
snFdbStationEntrySize
brcdIp.1.1.3.1.23
Syntax: Integer32 Read only Specifies the size of each FDB station table entry.
snPortStpEntrySize
brcdIp.1.1.3.1.24
Syntax: Integer32 Read only Specifies the size of each port STP table entry.
snSwIpxL3SwMode
brcdIp.1.1.3.1.28
Syntax: Integer Read-write Indicates whether or not Layer 3 IPX Switch mode is enabled.
•
disabled(0)
•
enabled(1)
Default: disabled(0)
snVLanByIpSubnetMaxSub
nets
brcdIp.1.1.3.1.29
Syntax: Integer Read only Applies only to ServerIron products.
Shows the maximum number of subnets for each IP VLAN.
snVLanByIpxNetMaxNetwor
ks
brcdIp.1.1.3.1.30
Syntax: Integer Read only Applies only to ServerIron products.
Shows the maximum number of networks for each IPX VLAN.
Name, OID, and Syntax Access Description