Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 68)

56 Brocade Virtual ADX MIB Reference
53-1003312-01
Switch port information
snSwIfVlanId
brcdIp.1.1.3.3.5.1.24
Syntax: Integer Read only Shows the ID of a VLAN of which this port is a member. Port must
be untagged.
Valid values: 0 – 4095; where 0 means an invalid VLAN ID value,
which is returned for tagged ports.
snSwIfRouteOnly
brcdIp.1.1.3.3.5.1.25
Syntax: Integer Read-write Indicates if Layer 2 switching is enabled on a routing switch port.
•
disable(0) – Instructs the routing switch to perform routing
first. If that fails, it performs switching.
•
enable(1) – Instructs the routing switch to perform routing
only.
For a Layer 2 switching only product, reading this object always
returns "disabled". Writing "enabled" to this object takes no effect.
Default: disabled(0)
snSwIfPresent
brcdIp.1.1.3.3.5.1.26
Syntax: Integer Read only Applies only to M4 modules and FES.
Indicates if the mini-GBIC optic is absent or present.
•
false(0)
•
true(1)
snSwIfGBICStatus
brcdIp.1.1.3.3.5.1.27
Syntax: Integer Read only Indicates if the Gigabit port has a GBIC or miniGBIC port:
•
GBIC(1) – GBIC
•
miniGBIC(2) – MiniGBIC
•
empty(3) – GBIC is missing
•
other(4) – Not a removable Gigabit port
snSwIfLoadInterval
brcdIp.1.1.3.3.5.1.28
Syntax: Integer Read-write Shows the number of seconds for which average port utilization
should be calculated.
Valid values: 30 – 300, in 30 second increments.
Default: 300 seconds
snSwIfStatsInFrames
brcdIp.1.1.3.3.5.1.29
Syntax: Counter Read only Shows the total number of packets received on the interface.
snSwIfStatsOutFrames
brcdIp.1.1.3.3.5.1.30
Syntax: Counter Read only Shows the total number of packets transmitted out of the
interface.
snSwIfStatsAlignErrors
brcdIp.1.1.3.3.5.1.31
Syntax: Counter Read only Shows the number of dot3StatsAlignmentErrors, which consists
of frames received on a particular interface that are not an
integral number of octets in length and do not pass the FCS
check.
The count represented by an instance of this object is
incremented when the alignmentError status is returned by the
MAC service to the LLC (or other MAC user). According to the
conventions of IEEE 802.3 Layer Management, received frames
for which multiple error conditions are obtain are counted
exclusively according to the error status presented to the LLC.
snSwIfStatsFCSErrors
brcdIp.1.1.3.3.5.1.32
Syntax: Counter Read only Shows the number of dot3StatsFCSErrors, which consists of
frames received on a particular interface that are an integral
number of octets in length but do not pass the FCS check.
The count represented by an instance of this object is
incremented when the frameCheckError status is returned by the
MAC service to the LLC (or other MAC user). According to the
conventions of IEEE 802.3 Layer Management, received frames
for which multiple error conditions are obtain are counted
exclusively according to the error status presented to the LLC.
Name, OID, and Syntax Access Description