Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 64)

52 Brocade Virtual ADX MIB Reference
53-1003312-01
Switch port information
snSwIfInfoMonitorMode
brcdIp.1.1.3.3.5.1.2
Syntax: Integer Read-write Indicates the method used to monitor traffic on a port:
•
disabled(0) – No traffic monitoring.
•
input(1) – Traffic monitoring is activated on packets received
•
output(2) – Traffic monitoring is activated on packets
transmitted
•
both(3) – Traffic monitoring is activated on packets received
and transmitted.
Default: disabled(0)
snSwIfInfoMirrorPorts
brcdIp.1.1.3.3.5.1.3
Syntax: Integer Read-write Contains a list of port or interface indexes (ifindex) that mirror this
interface when monitoring is enabled.
snSwIfInfoTagMode
brcdIp.1.1.3.3.5.1.4
Syntax: Integer Read-write Indicates if the port has an 802.1q tag:
•
tagged(1) – Ports can have multiple VLAN IDs since these
ports can be members of more than one VLAN.
•
untagged(2) – There is only one VLAN ID per port.
snSwIfInfoTagType
brcdIp.1.1.3.3.5.1.5
Syntax: Integer32 Read-write Indicated the interface’s IEEE802.1q tag type. The tag type is
embedded in the two octets in the length/type filed of an
Ethernet packet.
snSwIfInfoChnMode
brcdIp.1.1.3.3.5.1.6
Syntax: Integer Read-write Indicates if the port operates in half- or full-duplex mode:
•
halfDuplex(1) – Half duplex mode. Available only for 10/100
Mbps ports.
•
fullDuplex(2) – Full duplex mode. 100BaseFx,
1000BaseSx, and 1000BaseLx ports operate only at
fullDuplex(2).
The read-back channel status from hardware can be:
•
none(0) – Link down or port disabled.
•
halfDuplex(1) – Half duplex mode.
•
fullDuplex(2) – Full duplex mode.
The port media type (expansion or regular) and port link type
(trunk or feeder) determine the value of this object. The port
cannot be set to half duplex mode if the port connect mode is
m200e(4). However, the value of this parameter may be
automatically set whenever the expansion port is connected, for
example, in the case of cascade connecting device.
Name, OID, and Syntax Access Description