Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 224)

212 Brocade Virtual ADX MIB Reference
53-1003312-01
Monitor groups
Real server port history control group
Real Server Port History Control Table lists all the controls for collecting data samples for a real
server port.
Name, OID, and Syntax Access Description
snL4RealServerPortHistoryContro
lTable
brcdIp.1.1.4.28.3 None Real Server Port History Control Table
snL4RealServerPortHistoryContro
lEntry
brcdIp.1.1.4.28.3.1 None An entry in the Real Server Port History Control Table.
snL4RealServerPortHistoryContro
lIndex
brcdIp.1.1.4.28.3.1.1
Syntax: Integer Read only An index that uniquely identifies an entry in this table. Each
entry defines a set of samples at a particular interval for a real
server port on the ServerIron.
Valid values: Up to 65535 entries.
snL4RealServerPortHistoryContro
lDataSource
brcdIp.1.1.4.28.3.1.2
Syntax: Object Identifier Read-write This object identifies the source of the historical data that was
collected for this entry. The source can be any real server port
on this ServerIron.
It identifies a particular instance defined in the
“snL4RealServerStatisticTable” .
It may not be modified if the value of the
“snL4VirtualServerPortHistoryControlStatus” object for this
entry source is equal to valid(1).
snL4RealServerPortHistoryContro
lBucketsRequested
brcdIp.1.1.4.28.3.1.3
Syntax: Integer Read-write The requested number of data samples that will be saved for
this entry. The number of actual samples saved in the
“snL4RealServerPortHistoryControlBucketsGranted” object
should be close to the value of this object. If the value of this
object is modified, then the value of the
“snL4RealServerPortHistoryControlBucketsGranted” object
will be adjusted according to the new value of this object.
Valid values: 1 – 65535
Default: 50
snL4RealServerPortHistoryContro
lBucketsGranted
brcdIp.1.1.4.28.3.1.4
Syntax: Integer Read only The number of data samples that was actually saved for this
entry.
If the value of the
“snL4RealServerPortHistoryControlBucketsRequested” object
is modified, then the actual number of samples saved by this
object will be adjusted accordingly.
If all the requested buckets are filled, a new bucket will be
added to the table, and the oldest bucket for the entry will be
deleted.
If the value of this object changes to a value less than the
current value, enough of the oldest entries will be deleted so
that the number of buckets does not exceed the new value of
this object.
If the value of this object changes to a value greater than the
current value, the number of buckets will increase but will not
exceed the new value of this object.