Teledyne LeCroy Sierra M124 User Manual - Manual (Page 374)

Teledyne LeCroy Display Options
372 Sierra M124 SAS/SATA Protocol Analyzer User Manual
Figure 5.33: Connection Parameters Dialog
You can set the “Identify” frame parameter settings to keep the link connected:
 Device Type: End Device, Edge Expander, or Fanout Expander
 SSP Initiator: Present or Not Present
 STP Initiator: Present or Not Present
 SMP Initiator: Present or Not Present
 SSP Target: Present or Not Present
 STP Target: Present or Not Present
 SMP Target: Present or Not Present
 SAS Address (hex): eight digits ‐ eight digits
 PHY Identifier (hex): two digits
 Zone Device: Yes or No
 Zone Broadcast Method (hex): two digits
You can select to not show the dialog until there is a generation mode change.
5.12.3 Resetting the Toolbar
The Analyzer Toolbar has the following:
 Launch Jammer: Switches to InFusion frame.
 Launch Analyzer : Switches to Analyzer frame.
 Start Recording: Start Analyzer without switching to Analyzer frame.
 Stop Recording: Stop Analyzer without switching to Analyzer frame.
 Abort Recording: Abort Analyzer without switching to Analyzer frame.
The Generator Toolbar has the following:
 Start Generation