Teledyne LeCroy Sierra M124 User Manual - Manual (Page 137)

Sierra M124 SAS/SATA Protocol Analyzer User Manual 135
Analysis Teledyne LeCroy
STP Transport Report (SAS)
To display the STP Transport Report, click the STP Transport tab. The STP Transport Report
displays the report data in columns with the following information (see
Figure 3.35 on
page 135 ):
 FIS Type: All, Custom, Data, PIO Setup, Register Host To Device,
Register Device To Host
 PM Port
 Direction: All, I‐>T, T‐>I, or Custom
 Duration: All, Custom, or time unit
 Count: All, Custom, or a number
 %: of total count
Figure 3.35: SAS: STP Transport Report
SCSI Command Report (SAS)
To display the SCSI Command Report, click the SCSI Command tab. The SCSI Command
Report displays the report data in columns with the following information:
 Command: All, Custom, Inquiry, Mode Sense6, Pause Resume, Play Audio 10,
Read Capacity, Read10, Receive Diagnostic Results, Send Diagnostic, Write10,
Start Stop Unit, Test Unit Ready, Report Luns, Synchronize Cache10
 Direction: All, I‐>T, T‐>I, or Custom
 Number of Transport: All, Custom, or a number
 Payload Size: All, Custom, or a number of DWORDs
 Status: All, Custom, Good, Incomplete, Response Data Present
 Task Attribute: Simple
 Duration: All, Custom, or time unit
 Count: All, Custom, or a number
 %: of total count
Figure 3.36: SAS: SCSI Command Report
SMP Command Report (SAS)
To display the SMP Command Report (see Figure 3.37 on page 136 ), click the SMP
Command tab. The SMP Command Report displays the report data in columns with the
following information:
 Function: All, Custom, Discover, Report General,
Report Manufacture Information, Report PHY Error Log