Teledyne LeCroy Sierra M124 User Manual - Manual (Page 348)

Teledyne LeCroy Sierra Trainer Generation Language
346 Sierra M124 SAS/SATA Protocol Analyzer User Manual
AutoMode Settings
AutoOOBMode
On When set, the generator will go through the stages of
bringing up the link automatically, including waiting
for and responding to the device or host it is
connected to.
AutoHoldMode 0 When set, the generator will respond automatically
to Hold requests. Not supported for version 1.1
(reserved).
AutoDMAT 0 When set, the generator will respond automatically
to DMAT requests. Not supported for version 1.1
(reserved).
AutoSpeedNeg On When set, the generator will automatically go
throughthe speed negotiation process, for the speed
set in the PINTERFACEC_SERDES register for the
Trainer.
AutoAlignSATA 0 When set, the generator will automatically inserting
the stream 2 Align(0) primitives every 254
DWORD s, as
specified in the SATA spec.
AutoAlignSAS On When set, the generator will automatically inserting
the stream Align primitives every 2048
DWORD s, as
specified in the SAS spec.Two Align modes can be
turned on simultaneously, to support STP
COMINIT Settings
COMINIT_NegLen
800 The number of bursts to send as part of this OOB
type.Each Burst is followed by an Idle. The Burst‐Idle
pairs are repeated the requested number of times,
and then followed by the Negation_length of Idle.
COMINIT_IdleLen 480 Burst time between each OOB idle in OOBIs.During
the specified period, the generator will send
ALIGN(0) at the specified speed.
COMINIT_BurstLen 160 Idle time between each OOB burst in OOBIs.During
the specified period, the generator will keep the line
at electric idle.
COMINIT_NumBursts 6 Negation time at the end of the OOB signal in
OOBIs.During the specified period, the generator will
keep the line at electric idle.
Setting
Default
Value
Description