Teledyne LeCroy Sierra M124 User Manual - Manual (Page 337)

Sierra M124 SAS/SATA Protocol Analyzer User Manual 335
Sierra Trainer Generation Language Teledyne LeCroy
 SAS_AF_RATE_1_5_GBPS
 SAS_AF_RATE_3_GBPS
 SAS_AF_RATE_6_GBPS
 SAS_AF_RATE_12_GBPS
 SMP_FRAME_TYPE_REQUEST
 SMP_FRAME_TYPE_RESPONSE
 SMP_REPORT_GENERAL
 SMP_REPORT_MANUFACTURER_INFO
 SMP_DISCOVER
 SMP_REPORT_PHY_ERROR_LOG
 SMP_REPORT_PHY_SATA
 SMP_REPORT_ROUTE_INFO
 SMP_CONFIGURE_ROUTE_INFO
 SMP_PHY_CONTROL
 SSP_FRAME_TYPE_DATA
 SSP_FRAME_TYPE_XFER_RDY
 SSP_FRAME_TYPE_COMMAND
 SSP_FRAME_TYPE_RESPONSE
 SSP_FRAME_TYPE_TASK
 SSP_FRAME_TYPE_VENDOR
 MUX (LOGICAL 0)
 MUX (LOGICAL 1)
 BREAK_REPLY
 TRAIN
 TRAIN_DONE
 PS_ACK
 PS_NAK
 PS_REQ_PARTIAL
 PS_REQ_SLUMBER
Primitive Category
 ALIGN: 0, 1, 2, or 3
 NOTIFY: ENABLE SPINUP, RESERVED 0, RESERVED 1, or RESERVED 2
 ACK
 NAK: CRC ERROR, RESERVED 0, RESERVED 1, or RESERVED 2
 RRDY: NORMAL, RESERVED 0, RESERVED 1
 AIP: NORMAL, RESERVED 0, RESERVED 1, RESERVED 2, RESERVED 3, WAITING ON
CONNECTION, WAITING ON DEVICE, or WAITING ON PARTIAL
 BREAK
 CLOSE: CLEAR AFFILIATION, NORMAL, RESERVED 0, RESERVED 1
 CREDIT BLOCKED
 OPEN ACCEPT
 OPEN REJECT: BAD DESTINATION, CONNECTION RATE NOT SUPPORTED, NO DES‐
TINATION, PATHWAY BLOCKED, PROTOCOL NOT SUPPORTED, RESERVED ABAN‐
DON 0, RESERVED ABANDON 1, RESERVED ABANDON 2, RESERVED ABANDON 3,
RESERVED CONTINUE 0, RESERVED CONTINUE 1, RESERVED INITIALIZE 0,
RESERVED INITIALIZE 1, RESERVED STOP 0, RESERVED STOP 1, RETRY, STP
RESOURCES BUSY, or WRONG DESTINATION