Teledyne LeCroy Sierra M124 User Manual - Manual (Page 20)

Teledyne LeCroy Installing Your Analyzer
18 Sierra M124 SAS/SATA Protocol Analyzer User Manual
1.7 Installing Your Analyzer
1.8 Software Installation
The SAS and SATA software works on systems using the Windows® XP, Windows 7 (x86,
x64) Windows 8 (x86, x64), Windows Server 2003, Windows Server 2008 and Windows
Server 2012 R2 operating systems. 64‐bit Windows OS is recommended because it allows
using more RAM memory. Other Operating Systems limit the RAM to 3GB.
1. Insert the Installation CD ROM into the CD/DVD drive on the host machine.
2. The installation automatically starts setup, unless Auto Run is off. In that case, select
the CD ROM from “My Computer” and click Setup.
3. After the warning to close all other programs and before starting the installation,
the Install component selection opens.
4. Select components for installation.
5. Click Next to complete the installation.
1.8.1 System restart
You must restart your computer before you can use your Protocol Suite software.
1.8.2 Error Message
If you get an error message during installation of the drivers for Window, consult your
system administrator. Your system may allow only administrator‐level users to copy such
driver files.
1.9 Hardware Setup
1.9.1 Separate Systems
When using the analyzer, it is recommended to use a system to generate bus traffic and a
second system to run the software, to avoid characterization of traffic generated by the
analyzer.
1.9.2 Connecting in General
Note: You must install the software before connecting the analyzer to the host machine for the first
time.
To set up the analyzer:
1. Plug the power adapter into the unit, and then plug the power adapter into a 100V–
240V, 50Hz–60Hz, power outlet. Turn on the Power switch.
At power on, the analyzer will go through initialization as shown on the LCD display.