EVS MulticamLSM Version 8.03 - Dec 2006 User's Manual - Manual (Page 80)

EVS MULTICAM - User’s Manual Version 8.03
EVS Broadcast Equipment SA – Dec 2006
78
ƒ
ƒ PGM X : located in the bottom right corner of the clip screen, this
field is only visible if the “Call Channel VGA” function has been
enabled in the Setup Menu (p. 3.1 – F5) or in the Setup Screen,
and is only effective in CAM mode, not in CLIP mode. It allows
the operator to select on which channel clips called using the
keyboard/tablet and VGA should be loaded. Press ALT + F1 on
the keyboard to select PGM1, ALT + F2 for PGM2/PRV, ALT + F3
for PGM3, etc. This function is useful to load clips on channels
that can not be controlled by an EVS remote panel, or to allow an
AP to browse clips on a play channel not used by the main
operator. Note that if that channel is in PLST EDIT mode with a
PRV, the clip will automatically cue up on the PRV.
MOVING AND COPYING CLIPS AND PLAYLISTS
Clipboard field: This area displays the content of the clipboard :
clip/playlist number, network number if the copied clip/playlist is a remote
clip/playlist, and the selected camera(s) for a clip.
The rest of the line summarize the available functions (copy, cut, paste,
delete) and their keyboard shortcuts. These functions can also be called
by clicking on the corresponding area on this line.
CTL+ X: CUT
1. Move the cursor to the clip/playlist to “cut” from the Clip Screen
2. Press CTRL + X on the keyboard or click on the corresponding
area on the screen.
CTL+C: COPY
1. Move the cursor to the clip/playlist to copy
2. Press CTRL + C on the keyboard or click on the corresponding
area on the screen.
CTL+V: PASTE
1. Move the cursor to the clip/playlist location where the content of
the clipboard should be copied.
2. Press CTRL + V or click to the corresponding area on the screen.
Notes:
- If the clip board was filled using the CUT function, the original clip(s) is(are) deleted
after being pasted to the new location.
- In CAM mode, only the selected camera of the clip is CUT/COPIED/PASTED
- In CLIP mode, all camera angles of the clip are CUT/COPIED. For the PAST function
in CLIP mode, only the available camera locations inside the destination clip will be
pasted. If some camera angles already exist for the destination clip, these will not be
overwritten by the corresponding camera in the clipboard.
!
Important notes :