EVS MulticamLSM Version 8.03 - Dec 2006 User's Manual - Manual (Page 74)

EVS MULTICAM - User’s Manual Version 8.03
EVS Broadcast Equipment SA – Dec 2006
72
THE FUNCTION BAR
The second line displays the available functions. Each function can be
called by the corresponding F_ key of the keyboard, or by clicking with
stylus & tablet on the corresponding area on this line.
F1:Name
This function is used to name a clip.
1.
Within the clip screen, choose the clip to name either by clicking on
it with the stylus or by positioning the green arrows around the
desired clip with the keyboard.
2. Type in the desired name with the keyboard. All characters
available from the keyboard are accepted, including blanks.
3. Press F1:
→ in CAM mode, only the camera where the cursor is located is named
→ in CLIP mode, all cameras of the clip where the cursor is located
are named.
The entry in the Name field is not cleared by pressing F1 and remains for
future usage. Press [Backspace] to delete the last character in the Name
field, or press [ESC] to clear the whole field.
Note: To be able to name or rename clips on a network machine, the “Clip Edit by Network”
parameter in the setup of the remote machine must be set to “Yes” (VGA Setup
Screen) or “Enabled” (Setup Menu on the EVS remote panel). If you are unable to
name a network clip, please first check this parameter on the remote machine.
F2:Clip/Cam
This function toggles between CLIP mode and CAM mode. In CLIP mode,
actions on a clip will use all available cameras for this clip. In CAM
mode, actions on a clip will only use the selected camera for this clip.
Other functions such as NAME, DELETE, COPY, SET TC, >ARCHIVE
depend on this mode’s selection.
F3:Call
The operator can gain immediate access to a local or network clip by
typing its ID number:
To call a clip belonging to the machine you are currently connected
to (indicated on the left side of the Title Bar) :
1. Type either the 3 or 4 digits of the ID. Ex : 111 or 111A. The entry
appears in the Name field.
2. Press F3
→ If only 3 digits are entered, the primary camera is selected
→ If 4 digits are entered, the clip is selected according to the given
camera angle.
→ If no clip matches the entry, no selection is done.
Note: [ESC] key can still be used at any time to clear the Name field.