EVS MulticamLSM Version 8.03 - Dec 2006 User's Manual - Manual (Page 49)

EVS MULTICAM - User’s Manual
EVS Broadcast Equipment SA – Dec 2006
Version 8.03
47
you must press a F_ key to select the corresponding page (1 to 10).
SELECTION OF CLIP BANKS AND PLAYLISTS
SHIFT + F1 - F9 = CLIPS BANK
This allows access to clip banks 1 through 9 within the clip page
(1 to 10).
SHIFT - F1 = BANK 1
SHIFT - F2 = BANK 2, etc. (up to bank 9)
Once in the bank, selection of the F1 – F10 keys will call up the
respective clips. If “Recall Clip Toggle” is enabled in the setup menu,
pressing several times on the same F_ key will call successively all
camera angles of that clip.
The clip numbering system is as follows:
Clip 547 “5” Denotes the CLIP PAGE number (1 to 10).
“4” Denotes the CLIP BANK (1 to 9)
“7” Denotes the clip number (1 to 10) inside the bank
Note: To identify remote clips when using the XNet SDTI network, the number of the clip is
followed by the number of the machine on the network. i.e. Clip 547B/04
SHIFT - F10 = PLAYLIST BANK
This combination of keys gives access to the playlists’ banks. Within
each CLIP PAGE there are 10 playlists. Selecting F1-F10 at this point
calls up the corresponding playlist.
Playlist 51 “5”
Denotes the CLIP PAGE
“1” Denotes the playlist number (1 to 10)
Note:
- The playlist bank of page 10 is not available from the EVS remote, since it is actually
reserved for the EVS AVSP protocol (for Air Box and Air Edit).
- To identify remote playlists when using the XNet SDTI network, the number of the
playlist is followed by the number of the machine on the network, i.e. Playlist 51/04