EVS MulticamLSM Version 8.03 - Dec 2006 User's Manual - Manual (Page 68)

EVS MULTICAM - User’s Manual Version 8.03
EVS Broadcast Equipment SA – Dec 2006
66
GOTO IN AND GOTO OUT
You can use Goto IN and Goto OUT functions to jump immediately onto
SHORT IN or SHORT OUT points respectively.
HOW TO RESTRIPE THE TIME CODE OF A CLIP ?
1. recall the clip by pressing the corresponding F_ key;
2. move the jog dial to reach the picture where you want to define a new
time code;
3. press the MENU key to access the secondary menu;
4. press SHIFT + C to call the SET TC function and enter the new time
code for the current picture. In 59.94Hz modes (NTSC), the operator
can also select between DROP FRAME and NON DROP FRAME modes
by pressing SHIFT+MENU.
5. Press the D key to select CAM or CLIP mode. In CAM mode, only the
timecode of the camera angle loaded on the primary channel will be
changed. In CLIP mode, the time code of all camera angles of the clip
will be changed.
6. Press ENTER to confirm, or MENU to cancel.
7. The entire clip is updated according to the new time code value so that
the time code remains continuous inside the whole clip.
The next time this function is called the value previously used will be set
as default.
SECONDARY MENU IN CLIP MODE
In Clip Mode, the secondary menu of the remote panel is different from
the Record Train mode :
Press MENU to access the secondary menu. If no keyword file is
selected in the setup, the LCD display will be :
P G M 1 1 1 2 A * P R V 1 * 1 1 2 B
P u s h A u x C l i p S o r t - > T C P o s t R o l l
> A r c h i v e * * * N a m e C a m
P . 1 B . 1 C l i p s : L o c a l R e c o r d s : L o c a l
P L 1 1 : < >
M s g :
R s t C a m L o c a l S y n c P r v 2 n d C T R L
C a m A C a m B C a m C C a m D
1 k e y w o r d 8 9 0 1 2 3 2 k e y w o r d 8 9 0 1 2 3 k e y w o r d 8 9 0 1 2
1 1 1 A
P u s h A u x C l i p S o r t - > T C P o s t R o l l
> A r c h i v e * * * C a m