EVS MulticamLSM Version 8.03 - Dec 2006 User's Manual - Manual (Page 46)

EVS MULTICAM - User’s Manual Version 8.03
EVS Broadcast Equipment SA – Dec 2006
44
PLST :
Not active if current playlist is empty. If the current playlist is not empty,
pressing PLST once enters the Playlist Edit mode.
Pressing PLST from the Playlist edit mode enter the Playlist diffusion
mode.
Pressing PLST from the Playlist diffusion mode re-cues the playlist to its
beginning.
Pressing 3 times PLST will always cue up the playlist ready to roll.
To play back a playlist that has been cued, press the PLAY button and it
will roll at the preset speeds.
BROWSE:
When a clip is loaded on the primary channel, pressing the BROWSE key
allows the operator to browse inside all local clips of the database by
turning the jog knob.
When a cue point exists for the current picture on the primary channel
(the CUE button lights red), pressing the BROWSE key allows the
operator to browse through all existing cue points by turning the jog knob.
When the current picture on the primary channel is not a clip nor a cue
point, or if the operator is in Playlist mode, pressing the BROWSE key
allows him to browse inside the clips of the current playlist by turning the
jog knob.
INSERT:
To insert a clip before or after (depending on the setup menu) the current
position inside the playlist.
ENTER :
Appends CLIP(s) at the end of the current PLAYLIST, also to confirm
saving of CLIPS, and validate various options and messages.
MENU:
Enables operator to gain access to the secondary menu.
SHIFT+MENU gains access to the Main Menu.
Also used as an ESCAPE key to cancel some options and messages.
CLEAR :
to clear IN / OUT/ PLAYLISTS / CLIPS / CUE points.
Note:
- To clear 1 CUE point, recall the desired cue point and press CLEAR + MARK key
- To clear all cues: when current picture is not a CUE point, press CLEAR + MARK key.
A message appears to confirm the command.