EVS MulticamLSM Version 8.03 - Dec 2006 User's Manual - Manual (Page 124)

EVS MULTICAM - User’s Manual Version 8.03
EVS Broadcast Equipment SA – Dec 2006
122
between Internal Loop or External Loop.
The Internal Loop is the same loop as the existing loop process.
The External Loop allows you to select on which channel you will
physically re-record the output of your PGM. The link is physical : it is
necessary to make the video link manually with a router or vide/audio
cables, it is not done inside the server.
Additional parameters are available for the external loop :
- In Shift C, you can select to which camera the PGM will be recorded
for the external LOOP process. Press Shift C until the desired camera
is selected.
- In Shift D, you can select by how much the video coming back to your
record channel will be delayed. If you are using a DVE, it could
introduce a delay. This system is based on the assumption that Audio
and Video are in sync when they hit the record channel. The delay
value can not be negative.
Select Shift D to highlight the delay value and the display allows you
to add frames or fields of delay to the delay value. Pressing either
MENU or SHIFT+D will leave this mode.
REPLACE PLAYBACK MODE
When the in and out points have been marked, the Int Loop and the Ext
Loop keys are blinking.
Pressing one of the two keys activates the Replace Playback Mode : the
playlist is cued before the in point (to create guardbands), ready to be
initiated.
A message appears on remote : ‘start replace : lever or play button’.
The play can be activated by pressing the play button or moving the
lever.
The playlist is played at the speed defined in the playlist but the lever
can also be used to vary the playback speed.
When the end of the clip (out point + guardband) is reached, a clip
containing the in and out point with the guardbands is created on the
receive page defined in the setup menu. The loop is stopped and the user
switches back to match frame edit mode.
A confirmation message pops-up
Replace in/out by clip xxx ?
MENU : Cancel – ENTER : OK.
If the operator presses ‘enter’, the material between the in and out points
is replaced with the newly created clip. The playlist returns to playlist edit
mode, positioned at the end of the inserted clip.
If the user cancels the operation, the playlist remains in replace edit
mode.