EVS MulticamLSM Version 8.03 - Dec 2006 User's Manual - Manual (Page 152)

EVS MULTICAM - User’s Manual Version 8.03
EVS Broadcast Equipment SA – Dec 2006
150
P G M 1 C A M A * P G M 2 * C A M B
A u d . M e t . P g m S p d S o r t - > T C P o s t R o l l
S w t o I N S e a r c h P r e f
P . 1 B . 1 C l i p s : L O C A L R e c o r d s : L O C A L
P L 1 1 : <
M s g :
S p l i t M i x S w a p S y n c
L e f t R i g h t L & R 0 5 0 - 0 5 0 %
SPLIT MIX
This mode works similar to the H and V Split modes, except that there is
no position adjustment since both pictures are shown full frame.
The D key allows the operator to adjust the mix percentage between the
two sources. Press the D key to highlight the function, then move the
lever to adjust the mix level between the two sources.
AUTO-TRACKING MODE
The Auto-tracking mode applies only to the VERTICAL SPLIT mode, and
allows to adjust the horizontal position of a sequence to make sure it is
as close as possible to the center of the left/right part of the screen.
To use the Auto-tracking, the first step is to track the object that must be
kept in the center of the frame. Using the TARGET TRACK mode the
keyframes are marked to determine the path of the object. Refer to the
TARGET TRACK chapter of this manual for more details.
When the tracking is completed in the desired clips, enter the SPLIT
SCREEN mode and recall these clips on the left and right side of the
screen. If keyframes have been marked inside selected clips, the word
'TRACKED' will appear on the corresponding side of the monitoring
output. At playback, the picture will be shifted horizontally to keep the
tracked object in the center of its frame.
To disable temporarily the AUTO-TRACKING without leaving the Split
Screen mode, press CLEAR+LEFT (disable Auto-tracking on left side) or
CLEAR+RIGHT (disable Auto-tracking on right side).