EVS MulticamLSM Version 8.03 - Dec 2006 User's Manual - Manual (Page 63)

EVS MULTICAM - User’s Manual
EVS Broadcast Equipment SA – Dec 2006
Version 8.03
61
11. CLIP
Management
A clip is defined by SHORT IN and SHORT OUT points. When SHORT IN
and SHORT OUT points are set, the system automatically write protects a
user definable length of material before and after the SHORT IN/OUT
points respectively, these are referred to as the GUARD-BANDS.
It is possible to trim a clip by redefining SHORT IN and SHORT OUT
points.
Comments:
1. IN & OUT points of a clip cannot be replaced by new ones.
2. SHORT IN & SHORT OUT points of a clip can be replaced by new ones.
3. SHORT OUT point is excluded. The clip freezes on previous field when playing back
(with POST ROLL disabled).
4. (SHORT) IN & OUT are always on even fields. This is automatic.
5. The guardband beyond the SHORT OUT point is created with the material available
when the operator saves the clip by pressing the selected F_ key. Therefore, this
guardband can sometimes be shorter than the value defined in the Setup Menu.
If SHORT IN and SHORT OUT points are defined, only the fields
between those two points will be played if the sequence is recalled
(the same applies when the sequence is included in a play-list).
Fields between IN and SHORT IN and fields between OUT and
SHORT OUT (GUARD BANDS) can be reached with the JOG. So
the SHORT IN and SHORT OUT points can be redefined.