Avago Technologies LSI20160 - Manual (Page 97)

Using the NT Configuration Utility 4-29
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
4.6.2.6 Test Selection Menu
When you double click on a device in the Domain Validation - Current
Negotiated Settings menu, the Test Selection menu appears. The Sync
Speed and Bus Width values are preset to the current negotiated
settings of the selected device.
Figure 4.6 illustrates the Test Selections
menu.
The Adjustments box contains values that are changeable by you and
passed to the Windows NT miniport driver when the tests are executed.
Double click on an entry to change its value. The only values that can
be permanently changed at this level are the Sync Speed and Bus Width
values. Once all three test procedures have passed with the specified
values, click on the Apply button to save these new values. This action
also exits you from this menu. The
SYM_U3.SYS miniport driver begins
using these new values immediately.
Figure 4.6 Test Selections Menu
Test Selections
Help Code Defs.
Adjustments:
Sync Speed (MB/s) 40
Bus Width (in bits) 0 16
LVD Driver Signal Nominal
Req/Ack Skew Nominal
Data Pattern 0x00000000
Test Procedures Status (code):
Back-to Back Inquiries
Write/Read Buffers
Stress Pattern IOs
Apply Cancel