Avago Technologies LSI20160 - Manual (Page 130)

6-4 DOS Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
identifies the system, scans the SCSI bus, and properly installs the
required SCSI device drivers.
The SDMS Software Device Drivers and Utilities CD-ROM contains the
DOS device drivers along with the DOS Installation Utility.
To install the DOS Drivers using this utility, follow these steps:
Step 1. Copy the contents from this directory on the SDMS CD-ROM
{CD-ROM DRIVE LETTER}:\DRIVERS\DOS
to the root of a diskette.
Step 2. Reboot your system.
Step 3. Insert the newly created diskette into your floppy drive ( A: or
B: ), and type at a DOS prompt:
INSTALL
Step 4. Press Enter.
Step 5. Follow the directions presented on the screen.
When performing a custom installation, an understanding of the
information presented in the following sections for manual installation
may prove useful.
6.2.1 Troubleshooting
Here is a potential problem and a suggested solution:
If a menuing system exists in the CONFIG.SYS file and multiple menu
selections are available that already include some of the SDMS drivers,
the system only updates the first menu selection found that already
contains our drivers rather than all of them. However, if SDMS drivers are
not present, it puts the new drivers in the common area and creates a
common menu item one, if it does not exist.
A workaround regarding menuing in the CONFIG.SYS file is to ensure the
install program puts the drivers where you want them. By default they are
put in the common area. However, if some of the SDMS drivers are
already present, the install program may incorrectly guess where the new
ones should be put.