Avago Technologies LSI20160 User Manual

Page 80

4-12

Windows NT 4.0 Device Driver Installation

The system prompts for the manufacturer-supplied hardware
support disk.

Step 8.

Insert the appropriate SDMS driver diskette containing the
Windows NT driver, which was created in

This driver is required to support your LSI Logic adapter(s).

Step 9.

Enter or type the path to copy manufacturer’s files from:

A:\WINNT\MINIPORT

Select OK.

Step 10. Depending on the driver being installed, either

Symbios PCI

(53C8XX)

Symbios PCI High Performance Driver

, or

Symbios

Ultra3 PCI SCSI Driver

is shown highlighted on the Install

Driver menu. If it is not highlighted, select it. Choose OK.

At this point, the following message may occur:

The driver(s) for this SCSI Adapter are already on the

system. Do you want to use the currently installed

driver(s) or install new one(s)?

Selecting Current uses the driver already on the system, and
selecting New uses the driver on the diskette.

Step 11. Choose New unless you want to use the older version already

on the system. If you choose Current, go to

Step 12. Enter or type the path to the OEM SCSI Adapter files:

A:\WINNT\MINIPORT

Select Continue.

Step 13. Remove the diskette from your

drive.

The System Settings Change message displays

You must

restart your computer before the new settings take

effect. Do you want to restart your computer now?

Step 14. Click on the Yes button to restart and reboot Windows NT 4.0.

If you choose Cancel, remember that you must restart before
the new driver is loaded.

This manual is related to the following products: