Avago Technologies LSI20160 - Manual (Page 140)

6-14 DOS Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
Table 6.2 SYMDISK.SYS Command Line Options
Option
Name Description
/ASK Prompts you at system bootup whether to load SYMDISK.SYS or not. To use this option,
the line in the CONFIG.SYS file that loads SYMDISK.SYS should look like this:
DEVICE=C:[PATH]SYMDISK.SYS /ASK
/EXCLUDE Allows you to exclude a path:id:lun combination from being scanned or controlled
by SYMDISK.SYS . The path parameter is mandatory with all id s and lun s for that path
excluded by default if just the path is specified. To use this option, the line in the
CONFIG.SYS file that loads SYMDISK.SYS should look like this:
DEVICE=C:[PATH]SYMDISK.SYS /EXCLUDE=path[:id[:lun]][,path[:id[:lun]]]*
For example, if path 0 , id 2 , and lun 0 are designated, then the command line should
look like this:
DEVICE=C:[PATH]SYMDISK.SYS /EXCLUDE=0:2:0
Note: A limit of 24 path:id:lun combinations is allowed.