Avago Technologies LSI20160 User Manual
Page 76
4-8
Windows NT 4.0 Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
automatically adds the driver to the registry and copies the driver to the
appropriate directory.
Choose one of two methods to install these drivers onto a
Windows NT 4.0 system:
1.
Boot directly from the Windows NT CD-ROM.
or
2.
Use Windows NT Boot Diskettes.
Different steps are required depending on the method used. For
Compaq/DEC systems based on the Alpha processor, CD-ROM
installation is the only method available. The CD-ROM Installation and
Boot Floppy Diskette Installation procedures are listed below. Select the
appropriate installation for your system.
4.3.1.1 CD-ROM Installation
The driver that is bundled with Windows NT 4.0 is
SYMC810.SYS
. This
driver supports controllers that are listed in
Step 1.
Have the SDMS driver diskette available for inserting into the
A: drive when prompted.
Important:
Read Steps
and
before performing the instructions
contained within these steps.
Step 2.
Start the Windows NT 4.0 installation by booting from the
Windows NT CD-ROM:
For Intel-based systems, the system BIOS must support
booting from a CD-ROM. SDMS SCSI BIOS settings may need
to be changed to allow CD-ROM booting.
For Alpha-based systems, select Supplementary menu from
the firmware Boot Menu, and then select Install Windows NT
from CD-ROM.
Step 3.
Press the F6 key when the screen displays
Windows NT
Setup.
Note:
Be sure to press the F6 key as any driver loaded later in
the installation process is not recognized by the Windows