Avago Technologies LSI20160 User Manual
Page 78
4-10
Windows NT 4.0 Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
Step 2.
Start the Windows NT 4.0 installation by booting from the
Microsoft Setup diskette.
Step 3.
Press Enter when the Welcome to Setup screen appears.
The Windows NT Workstation Setup window appears.
Step 4.
Press S to skip automatic detection and do manual selection.
A screen displays the message “
Setup has recognized the
following mass storage devices in your computer...
”
Step 5.
Choose S to configure additional SCSI adapters when a screen
displays the SCSI adapters found.
Step 6.
Move the highlight bar to Other and press Enter.
The system prompts for the manufacturer-supplied hardware
support disk.
Step 7.
Insert the SDMS driver diskette containing the Windows NT 4.0
driver required to support your LSI Logic adapter(s) and press
Enter.
Step 8.
Depending on the driver being installed, either
Symbios PCI
(53C8XX), Symbios PCI High Performance Driver,
or
Symbios Ultra3 PCI SCSI Driver
is shown highlighted. Press
Enter to proceed.
Note:
If more than one SDMS driver needs to be installed, install
additional drivers one after the other using Steps
through
. Installation order is not important.
The Windows NT Workstation Setup window reappears.
Step 9.
Press S to load additional drives if using an IDE CD-ROM for
installation.
Another window appears. Proceed to Step 10;
or
If you have completed configuring additional SCSI adapters,
press Enter. Proceed to Step 11.
Step 10. Scroll up and select:
IDE CD-ROM
(
ATAPI 1.2)/PCI IDE Controller
Press Enter.