Avago Technologies LSI20160 - Manual (Page 57)

Installing Drivers for Windows 95/98/Me 3-11
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
A message should state that no drivers are installed for this
device.
Step 8. Click on the Change Driver... button.
Step 9. Select SCSI Controllers in the Select Hardware Type dialog
box.
Step 10. Click on the Have Disk button in the Select Device dialog box.
Step 11. Insert the SDMS driver diskette in drive A: (or B: ) and click OK.
If using drive B: , you must select it from the pick list.
Step 12. The Select Device dialog box should display Symbios 8xx PCI
SCSI Host Adapter , where 8xx matches the installed adapter.
Click on the OK button.
The Driver tab is updated to display the new driver files.
Step 13. Click on the OK button to install these driver files.
(Do not click on the Change Driver... button.)
The system copies the driver files and builds a new driver
database. The System Settings Change dialog box appears.
Ignore the message saying to turn off your computer and
change hardware settings.
Step 14. Remove the diskette from the drive and click on the Yes button
to shut down the computer.
Step 15. Press the Ctrl-Alt-Delete keys or the system reset button to
restart the system.
At this point, the new driver is operational. To confirm this, refer to
Section 3.3.4, “Verifying Correct Driver Installation.”
3.3.4 Verifying Correct Driver Installation
After installing or updating the SYMC8XX.MPD , SYM_HI.MPD , or SYM_U3.MPD
drivers, LSI Logic recommends that you verify the operation of these
drivers. Follow these steps to verify the correct driver has been installed.
Step 1. Check that all devices on the SCSI bus are available by using
the Windows Explorer option called “My Computer.”
Step 2. Double click on the My Computer icon.
All CD-ROMs available appear here.