Avago Technologies LSI20160 - Manual (Page 186)

8-6 SCO OpenServer 5 Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
To copy the raw dd image, follow these steps:
Step 1. Locate the SCO.DD image on the SDMS CD-ROM at:
{DOS CD-ROM Letter}:\DRIVERS\UNIXES\OPNSERVR
Step 2. Insert a formatted 3.5-inch (1.44 Mbyte) diskette into your A:
floppy drive.
Step 3. At the command prompt, type:
fdimage -qv sco.dd A:
Note: This command works when running MS-DOS, Windows 9x,
Windows Me, Windows NT, or Windows 2000. If you are
running antivirus software, LSI Logic recommends that you
temporarily disable it when running the fdimage program.
Otherwise, the fdimage program may not be able to get
exclusive access to your floppy drive, which it requires to
write the image to a diskette.
Step 4. Label this diskette “BTLD Driver Diskette.”
Step 5. Use the BTLD driver diskette for SCO OpenServer 5
installations to:
load the driver during the installation of the operating system,
or
access the devices on the SCSI bus after a SCO OpenServer 5
installation.
You may also download the current SCO OpenServer 5 driver from the
LSI Logic Web site at:
http://www. lsilogic.com. After you are
connected to this web site, place your cursor on the Get Drivers option
in the menu bar. Click on the Drivers selection. Choose the SCO
OpenServer 5 operating systems for SCSI and click on the Go button.
Follow the instructions on subsequent screens to download the drivers.
8.3 Installing the SDMS BTLD Driver
This section provides installation instructions for new and existing
systems and solutions to potential problems that may be encountered.