Avago Technologies LSI20160 User Manual
Page 77
Installing Drivers for Windows NT
4-9
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
setup. If F6 is not pressed, all devices controlled by the
drivers are not available during Windows NT setup.
Step 4.
Choose S to specify an additional device when the screen
displays
Setup could not determine the type of one or
more mass storage devices...
.
Note:
If this screen does not display as the first user input, then
the F6 key that was pressed in Step
was not seen by the
setup program. Reboot the system and try again.
The system prompts for the manufacturer-supplied hardware
support disk.
Step 5.
Insert the appropriate SDMS driver diskette containing the
Windows NT driver and press Enter.
This driver supports your LSI Logic adapter(s).
Note:
If more than one SDMS driver needs to be installed, install
additional drivers one after the other using Steps 4 through
6. Installation order is not important.
Step 6.
Depending on the driver being installed, either
Symbios PCI
(53C8XX), Symbios PCI High Performance Driver,
or
Symbios Ultra3 PCI SCSI Driver
is shown highlighted.
Press Enter to proceed.
Windows NT 4.0 should now recognize the miniport driver(s)
and the SCSI hardware.
Step 7.
Press Enter to continue.
Step 8.
Continue with the Microsoft Windows NT 4.0 installation
procedure at this point.
4.3.1.2 Boot Diskette Installation
This section provides installation steps when using a boot diskette. The
driver that is bundled with Windows NT 4.0 is
SYMC810.SYS
. This driver
supports controllers that are listed in
Important:
Read these steps before performing the instructions
contained within them.
Step 1.
Have the SDMS driver diskette available for inserting into the
A: drive when prompted to do so.