Avago Technologies LSI20160 - Manual (Page 185)

Building an SDMS 4.0 BTLD PCI Diskette 8-5
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
8.2.1 For UNIX System Users
To create the BTLD driver diskette, follow these steps:
Step 1. Insert a 3.5-inch diskette into the floppy drive.
Step 2. At the UNIX prompt, type:
dd if=//sco.dd of=/dev/fd0
The is the location of the dd image file.
This command will dd the image to the BTLD driver diskette.
Step 3. Label the diskette “BTLD Driver Diskette.”
8.2.2 For DOS and Windows System Users
Under this section, you may copy the sco. DD image file to a formatted,
blank diskette using the fdimage.exe utility.
Usage: fdimage [-dqsv] [-f size] [-r count] file drive
Table 8.1 describes the information selection options associated with this
executable program.
The SDMS Software Device Drivers and Utilities CD-ROM provides the
FDIMAGE.EXE utility in this directory:
{DOS CD-ROM Letter}:\DRIVERS\UNIXES\FDIMAGE.EXE
Table 8.1 FDIMAGE Information Selection Options
Options Description
-d Debug mode
-f size Specify the floppy diskette format by capacity; for
example, 160K, 180K, 320K, 360K, 720K, 1.2M,
1.44M, 2.88M
-q Quick mode: do not format the disk
-r count Retry count for format/write operations
-s Single-sector I/O
-v Verbose