Avago Technologies LSI20160 - Manual (Page 220)

10-14 Solaris Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
edit the symhisl.conf. file. The instructions for editing symhisl.conf
can also be found in the path /kernel/drv/symhisl.conf .
SYMHISL: Hardware not properly enabled by system,
cmd=xxxxh
The system has not properly enabled the configuration resources that the
symhisl driver needs in order to use this hardware. The cmd=xxxxh
value needs to be reported to technical support.
SYMHISL: Unsupported 64-bit register address. Please load
64-bit version of kernel and driver
This version of the symhisl driver does not support physical addresses
using 64-bit values. Contact LSI Logic Technical Support at 719-533-
7230 to determine if a new driver is available to support 64-bit version.
SYMHISL: The host adapter id in the .conf file is being
ignored because the SCSI BIOS Configuration Utility will
override it.
The symhisl.conf file has a line ( scsi-initiator-id=x ) that changes
the host adapter SCSI ID. That line is being ignored because the SCSI
BIOS Configuration Utility has set the SCSI ID. Please use the SCSI
BIOS Configuration Utility to change the SCSI ID.
SYMHISL: Ignored invalid scsi-initiator-id value = x
The symhisl.conf file has an invalid scsi-initiator-id value as
displayed in the error message. The allowable values are in the
range 0..15.
SYMHISL: property value is too large. Using maximum
value of .
A property value in the symhisl.conf file is greater than the maximum
allowed value. The driver will use the value instead.
SYMHISL: property value is too small. Using default
value of .
A property value in the symhisl.conf file is less than the minimum
allowed value. The driver will use the value instead.
SYMHISL: Could not allocate memory to read configuration
data.