Avago Technologies LSI20160 - Manual (Page 166)

7-6 OS/2 Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
•
Section 7.3.1, “Installing SYM8XX.ADD/SYM_HI.ADD During New
System Installations,” page 7-6
•
Section 7.3.2, “Updating SYM8XX.ADD/SYM_HI.ADD for Existing
System Installations,” page 7-7
Note: If you previously installed OS2CAM.ADD (a previous version
of the SYM8XX.ADD driver), delete OS2CAM.ADD and the
corresponding BASEDEV= statement in the CONFIG.SYS file
after you complete the installation procedures.
If you previously installed SYM8XX.ADD and/or SYM_HI.ADD
in a directory other than \OS2\BOOT , move SYM8XX.ADD
and/or SYM_HI.ADD to \OS2\BOOT , where the new versions
of these drivers can replace the old versions.
In both instances, the system will continue to boot using the
previous drivers until these steps are taken.
7.3.1 Installing SYM8XX.ADD/SYM_HI.ADD During New System
Installations
Your system configuration determines which installation instructions are
appropriate for you.
If neither your boot drive nor SCSI CD-ROM is connected to an LSI Logic
host adapter, install OS/2 and then add the drivers. Refer to the OS/2
Installation Guide for installing the operating system. Follow the steps in
Section 7.3.2, “Updating SYM8XX.ADD/SYM_HI.ADD for Existing
System Installations,” page 7-7
to add the drivers.
or
If your boot drive or SCSI CD-ROM is attached to an LSI Logic host
adapter, follow these steps:
Step 1. Make copies of the diskettes used for installation that are
included with the CD-ROM version of OS/2.
Step 2. Determine the appropriate driver(s) for installation by locating
the host adapter(s) to which the CD-ROM is attached in
Section 7.1.2, “LSI Logic Devices Supported.”
Step 3. Copy the indicated driver(s) from the SDMS OS/2 driver
diskette to the copy of Diskette 1.