Avago Technologies LSI20160 - Manual (Page 215)

Installing the SDMS Solaris Driver 10-9
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
Step 14. Select the device controller attached to the device that contains
your install medium.
Step 15. Press F2_Continue.
Drivers for the device controller that you selected are displayed.
Your system boots to run the install program. The install
program starts and your machine begins booting the complete
Solaris 7 or Solaris 8 operating environment.
Step 16. Proceed to configure your system when prompted to do so.
After configuring your system, click on the Begin Installation
button. The message indicated earlier appears now:
“ If you want to bypass the device configuration and
boot screens when the system reboots, eject the
Device Configuration Assistant/Boot diskette now .”
Step 17. Remove the Solaris Device Configuration Assistant Diskette.
Some time later, the following messages appear and prompt
you to insert each of the Solaris Driver ITU diskette(s) required
to install into your machine:
Installing unbundled device driver support
Extracting driver list from tree..
driver-name...
Please insert the Driver Update diskette labeled
Press when ready.
Step 18. Reinsert the SYMHISL Driver ITU diskette that you inserted
earlier into the diskette drive.
Step 19. Press Enter.
Packages and/or patches that contain the new drivers are
installed from the diskette onto your machine. Messages about
each installation appear accordingly.
Solaris 7: Two messages appear and prompt:
Do you want to create a new instance of this package [ y,
n, ?, q]
Type n for No and press Enter.