Avago Technologies LSI20160 - Manual (Page 201)

Building the C8XX Driver Diskette 9-3
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
•
LSI53C895 (LSI8951U, LSI8952U)
•
LSI53C895A (LSI8953U)
•
LSI53C896 (LSI22910, LSI21002, LSI22902)
•
LSI53C1000 (LSI20160, LSI20160L)
•
LSI53C1010 (LSI22915A, LSI21040, LSI22903, LSI21003,
ITI6200U3LP)
9.1.3 Description
The SDMS C8XX driver allows SCO UnixWare operating systems to
interface with SCSI devices connected to the LSI Logic family of chipsets
and/or LSI Logic associated host adapter boards.
Section 9.3, “Installing the C8XX Driver for Unixware,” describes the
procedures to install a new installation or update an existing installation
of UnixWare with the C8XX driver. You must first create a C8XX driver
diskette for installation purposes.
9.2 Building the C8XX Driver Diskette
The SDMS Software Device Drivers and Utilities CD-ROM contains the
dd image file for SCO UnixWare operating systems. The location of this
unixware.dd image file is in the UnixWare 7 directory.
{UNIX CD-ROM path}/drivers/unixes/unixware/uw7
To create a C8XX driver diskette to use with UnixWare installations, copy
the raw
dd image file onto a 1.44 Mbyte diskette. The driver diskette must
be built. Refer to the instructions below for UNIX System and DOS
System Users.
9.2.1 For UNIX System Users
Step 1. Insert a 3.5-inch diskette into the floppy drive.
At the UNIX prompt, type:
dd if=//unixware.dd of=/dev/fd0
The represents the location of the dd image file.
This command will dd the image to the C8XX driver diskette.