Avago Technologies LSI20160 - Manual (Page 240)

12-6 NetWare Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
To check the status of DOS drivers, follow these steps:
Step 1. Edit the CONFIG.SYS file.
Step 2. If any of the following lines appear, remove or delete these
lines. LSI Logic recommends using the
REM command to
comment them out in case these lines are needed later.
DEVICE=\DOSCAM.SYS
DEVICE=\MINICAM.SYS
DEVICE=\CDROM.SYS /d:
DEVICE=\SCSIDISK.SYS
DEVICE=\HIMEM.SYS
DEVICE=\EMM386.SYS
Step 3. Add the following lines if CD-ROM support is required:
DEVICE=\ASPI8XX.SYS
DEVICE=\SYMCD.SYS /d:
Step 4. Add the following line to the AUTOEXEC.BAT file:
DEVICE=\MSCDEX /d:
Note: The /d: is not a drive letter designation; it indicates the
name you wish assigned to your CD-ROM. You must
include the
NAME , which can be any combination of up to
8 characters.
12.3 Installing Drivers for NetWare
This section provides installation instructions for new and existing
NetWare systems.
12.3.1 New NetWare 5.XX Installations
This section provides the instructions for new NetWare 5.XX installations.
Read the steps before beginning the installation to familiarize yourself
with this procedure.
Step 1. Begin the file server installation according to the instructions in
the file server installation chapter in the Novell NetWare
Installation Manual.
The NetWare installation procedure prompts you for a Disk
Driver.