Avago Technologies LSI20160 User Manual

Page 119

Troubleshooting

5-15

Step 10. Press the

key when the screen displays:

Setup is

inspecting your computer's hardware

configuration

Be sure to press the

key to load the nonbundled drivers. For

example: the

SYM_U3.SYS

driver.

Step 11. Choose S to specify an additional device when the screen

displays:

Setup could not determine the type of one or more mass
storage devices....

The system prompts for the manufacturer-supplied hardware
support disk.

Step 12. Insert the appropriate SDMS driver diskette containing the

Windows 2000 driver required to support your LSI Logic
adapter(s) and press Enter.

Return to the Windows 2000 Setup screen.

Step 13. Press Enter to proceed.

The message about setup loading files appears.

The system prompts with another license agreement.

Step 14. Click on the Agreement selection.

The system displays partition table information.

Step 15. Press Enter.

The system prompts to continue setup.

Step 16. Press C.

Step 17. Select a new location to install Windows 2000 so that it does

not overwrite the information in the Windows NT section of your
hard drive. For example, the WINNT location appears.

Step 18. Press Esc to use a different location.

Step 19. Type in WIN2K for the system to create a new folder.

Step 20. Press Enter.

Step 21. Follow the Microsoft Windows 2000 installation procedure at

this point.

This manual is related to the following products: