Avago Technologies LSI20160 - Manual (Page 223)

Troubleshooting 10-17
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
A call to the operating systems’s ddi_dma_sync function failed. As a
result, the system data caches may not be properly synchronized with
system main memory. This may result in data corruption or failure of the
symhisl driver to function properly.
SYMHISL: ddi_dma_numwin() failed
SYMHISL: ddi_dma_getwin() failed
SYMHISL: ddi_dma_alloc_handle: h unknown/impossible
SYMHISL: ddi_dma_buf_bind_handle: DDI_DMA_INUSE
impossible
SYMHISL: ddi_dma_buf_bind_handle:h unknown/impossible
SYMHISL: ddi_dma_unbind_handle: failed
The operating system failed to respond to the named routine in a known
manner. This is a fatal error that is not recoverable. Report this error to
technical support.
SYMHISL: Device in a slave-only slot and is unusable
SYMHISL: Hi-level interrupts not supported
The adapter is in a slot that cannot be used with this driver. Try moving
the adapter to a different PCI slot.
SYMHISL: Failed to attach. This adapter will not be
installed.
Because of the previous error, this adapter could not be “attached” to the
I/O subsystem and will not be accessible. See the previous error
message and solve that problem.
SYMHISL: Failed to allocate memory
The symhisl driver was unable to allocate the memory needed during
initialization. You may have run out of available memory.
SYMHISL: Unbind failed!
The driver had a problem when attempting to unload itself. This is a fatal
error.
SYMHISL: Unable to obtain soft state structure