Avago Technologies LSI20160 - Manual (Page 204)

9-6 UnixWare 7 Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
Step 1. Boot the computer using the Install diskette(s) delivered with
the UnixWare Operating System distribution package.
UnixWare 7 provides two diskettes.
Step 2. Follow the instructions on the screen.
Step 3. Insert the PCI SCSI SCO UnixWare driver diskette when
prompted to insert the host adapter diskette and press Enter.
To install other host adapter drivers, insert the host adapter
diskette provided with the UnixWare 7 distribution package and
press Enter. If there are no other host adapter drivers to install,
continue the installation.
Note: During the installation, if the driver does not find a hard disk
on which to install the operating system, it aborts the process.
The system loads the required drivers, such as C8XX, and
indicates when they are loaded.
At the end of the installation you will see a prompt to reinsert
the driver diskette.
Step 4. Insert the PCI SCSI SCO UnixWare driver diskette and press
Enter.
The kernel is rebuilt, and the system gets ready to boot from
the SCSI disk drive.
Step 5. Remove the PCI SCSI SCO UnixWare driver diskette when
prompted to do so and reboot the system.
9.3.2 Existing System Installation
This section provides instructions for adding or updating the C8XX
package.
9.3.2.1 Adding or Updating the C8XX Package
Before you install the C8XX driver, make a backup copy of the existing
kernel:
Step 1. Log on as root.
Step 2. At the shell prompt, type:
cp /stand/unix /stand/unix.safe